|
|
楼主 |
发表于 2020-12-12 19:28:33
|
显示全部楼层
本帖最后由 爱神之心Mk.II 于 2020-12-13 09:55 编辑
红星新品(4824)-1/48 苏霍伊 苏-57隐身战斗机快速开盒
作者：ARC论坛上的Solo
Well, I have just received my kit. I am affraid there is no fun.
First of all, that kit is just a direct rescale of 1:72 kit. Period.
No details, empty wheel bays, empty cockpit, no rivets. Sorry, that is a ugly true.
Ok, here there are few pictures for you
.
The Box. Is nice and sturdy, but inside 2 hull halves were put inside without any plastic bag or safety foil.
In the box there are mentioned 2 hull halves plus 5 sprues with gray plastic and clear one.
That is all: for the model of the plane almost as big as Su-35 is is very poor content.
The Hull. Two halves, with very rough, rugged plastic. Wide and shallow panel lines. No rivets. Even one.
And what about details? Here you can see the cockpit:
...and the nose wheel bay:
The Sprues. First one mostly with inlets, cockpit and weapon bay doors. Second one one is mostly with many control surfaces. I can't see any otpions to make anything movable. Unlike the hull halves, all of the rest of plastic is very smooth. Strange.
Ok, that is details of main wheels bay:
That is second part of that bays. Also you can see nice nose gears. The gears and wheels are very good detailed. One of very few advantages of that kit.
Masterpiece of cockpit and ejection seat:
Third sprue is almost only with "details" of weapon bay and the R-77 missiles:
As you can see, the details are crispy and sharp, but there is lack of them.
There are also 2 sprues with exhaust nozzles, fuel tanks, and CH-31s, and many pylons and launchers as well.
Surprisingly, all of that is very nice and crispy. Exhaust nozzles have thin edges, nice details. There are nozzles for variants of aircraft.
Wheels are also very nice:
The same is with the missiles:
The pilot:
At the end there is a glass. Canopy and windshild are very nice: thin glass, very clear. There is small scratch on mine canopy what is a problem, because there is no possibilities to polish Zvezda glass - it makes very cloudy during sanding and polishing.
The Decals. Printed probably by Begemot. Very good quality, hard edges, everything is clear and detailed.
And that is all.
I can't say anything more than this kit is really, really big disappointment for me.
http://www.arcforums.com/forums/ ... ase-in-2020/page/3/
|
|
发表于 2020-8-13 18:45:37
